Torx HW

This actually had tri-point hardware, i believe it to be 2mm screws 

4.9 mm or a Socom Pivot Size pocket clip screw. Hard to confirm.

Torx screws, some of these had double glass breakers, one sometimes being a torx screw and the other being a glass breaker. 

2mm Chassis screws.

Glass breakers were the "Holes Style" Which can be removed by inserting a punch or an allen key or other similar item.

The Screws Grew alittle in size to 2.5mm from 2mm.

2.5 Domed Or 2.5 Flat Depending on various factors.

Also Some of the Glass breakers were the "Holes Style" Which can be removed by inserting a punch or an allen key or other similar item. Some of the later Flat body knives had the triangle glass breaker which you will need a large triangle or "UT Glass Bit"

2.5mm Domed chassis screw.

Glass breakers were the "Holes Style" Which can be removed by inserting a punch or an allen key or other similar item.

2.5mm Domed screws. 

Glass breakers were the "Holes Style" Which can be removed by inserting a punch or an allen key or other similar item.

Med Triangle chassis screws.

Large Triangle (UT Glass) for the glass breaker.

Med Triangle chassis screws.

Large Triangle (UT Glass) for the glass breaker.

Here is where we see the introduction of the contour chassis.

Med Triangle chassis screws.

Large Triangle (UT Glass) for the glass breaker.

The Jimping Changed on the handle of the contour chassis to wider and less.

Med Triangle chassis screws.

Large Triangle (UT Glass) for the glass breaker.

2mm Tri Point body screws Probably, im not sure on the glass breaker

Some had double mini "Hole Style" Glass Breakers, such as the urban full camo model.

Moden Models are Med Triangle chassis screws 

Large Triangle (UT Glass) for the glass breaker.

Oversized Hardware